SNOWJOE SJ627E Manual Del Operador página 8

Fig. 9
NOTE: Do not overtighten the knob.
Chute Crank Assembly
1. Remove the cotter pin from th lower chute crank (Fig. 10).
Fig. 10
2. Install the lower crank rod by inserting it into the opening
at the back of the housing with holes aligned (Fig. 11).
Fig. 11
Align the
holes
3. Secure the lower chute crank in place with the cotter pin
(Fig. 12).
Cotter Pin
Lower chute crank
Lower chute crank
Fig. 12
4. Remove the thumbscrew on the crank rod connector by
hand (Fig. 13).
Fig. 13
Crank
rod
connector
Lower chute
crank
5. Slide the upper chute crank through the rubber ring
located on the middle frame (Fig. 14).
Fig. 14
Rubber ring
6. Slide the upper chute crank into the crank rod connector
(Fig. 15).
8
Cotter pin
Thumbscrew
Upper chute crank