Pleasant Hearth 248-21-70S Manual Del Usuario página 30

INSTALLATION INSTRUCTIONS
1. Place the assembled mantel near a 15-amp, 120-volt grounded electric outlet.
Read all instructions before using this appliance.
2. Place the insert directly in front of the mantel opening (See figure 2).
3. Carefully lift the insert through the center opening in the front of the fireplace. The bottom of the
insert has two foam rubber strips to prevent scratching of the hearth base. Slide the insert back
through the opening until the metal trim makes contact with the front of the mantel.
4. Carefully position mantel with installed fireplace against wall.
5. Plug the power cord into the 15-amp, 120-volt outlet. Use an extension cord rated for a minimum
of 1,875 watts if necessary.
NOTE: This unit comes equipped with a safety switch on the side panel which disables
the heater (See figure 3).
To enable the heater, please ensure the switch is in the "On" mode. The heater will
function using the remote control or control panel on the front of the unit.
CAUTION: Make sure that the unit is installed so that the
power cord is not compressed against or caught on the
unit or the mantel and that it has an unobstructed path to
the grounded outlet.
Figure 2
Enable Heater/Calefacción habilitada/
Chauffage activé
Disable Heater/Calefacción deshabilitada/
Chauffage désactivé
Infrared Remote Control
9
Figure 3