Pleasant Hearth 248-21-70S Manual Del Usuario página 32

OPERATING INSTRUCTION
4
Timer Button:
This button controls the timer ON/OFF and 10-time setting from 30 minutes to 9 hours. When the
Timer is first turned on, it will come on at the shortest time setting (30 minutes). Each time the
Timer button is pressed, the time increases 1 hour, up to the longest setting (9 hours). Once the
set time expires, all fireplace functions will be automatically turned off.
5
Temperature/Timer Display
This LED display shows the set point for the temperature and timer functions. When either of
these functions is activated, the display reflects the set point for five seconds and then fades to
black. Any change in the set point of the temperature or timer will reactivate the display, which
again fades after five seconds.
The infrared remote control relies on a line of sight and must be pointed at the flame/screen of the
fireplace to work. The remote control unit has the controls required to turn ON/OFF both the main
power and the heater. If you prefer to use the touchpad
control on the fireplace unit itself, the layout
of the buttons on touchpads and remote control unit can
be seen in Figures 4 and 6, respectively.
1. Plug your fireplace into a 15-amp, 120-volt power outlet.
2. Turn the power on. Flame will show on the back screen
of the fireplace.
3. Remove plastic tab from inside battery compartment
to activate remote control (See Figure 5).
4. Point the remote control directly at the fireplace
flame/screen and use the buttons to operate the
fireplace.
Figure 5
The plastic tab inside the battery
compartment MUST be removed
before remote control will operate.
11
(Pull tab)