Adjusting The Wind Direction - Panasonic CZ-RWSU2 Instrucciones De Funcionamiento

7. Adjusting the Wind Direction

• Never try to manually move the fl ap (up-down wind direction plate) that is operated by the remote
control.
• When the unit stops, the fl ap (up-down wind direction plate) automatically faces downwards.
• When the unit is in heating standby, the fl ap (up-down wind direction plate) faces upward. Also,
bear in mind that the fl ap starts swinging after the heating standby mode is released, but the
display on the remote control indicates Auto Flap during standby heating as well.
CZ-RWSU2/CZ-RWST2/CZ-RWSL2/CZ-RWSY2/
Indoor Unit (CZ-RWSK2)/CZ-RWST3
Setting the Wind Direction
While the unit is operating, every time you press
direction the fl ap faces changes.
Setting Flap to Swing
If you press to set the fl ap (up-down wind direction
plate) in its most downward facing position, and then
press again,
automatically up and down.
Stopping Flap Swing
If you press again while the fl ap is swinging, you can
stop the fl ap from swinging and set it in place as desired.
Thereafter, if you press
starting from the most upward position.
• When the unit is in the Cool or Dry modes, the fl ap cannot
stop facing downwards. If you try to stop the fl ap from
swinging while it is facing downwards, it will continue
moving until it is in the third position from the top.
is displayed and the fl ap swings
, you can set the wind direction
Please face the fl ap (up-down wind
direction plate) downwards. If it faces
, the
upwards, the warm air will not reach
the fl oor level.
Please face the fl ap (up-down wind
direction plate) upwards. If the plate
faces downwards, condensation
may form and drip from around the
air outlet.
In the Fan Mode
Fan/Heat Modes
EN-11
In the Heat Mode
Initial Setting
In the Cool and Dry Modes
Initial Setting
In All Modes
Moves Constantly
Initial Setting
Displays with Swing Stopped
Cool/Dry Modes
EN