Additional Safety Warnings - Bosch BSH180 Instrucciones De Funcionamiento Y Seguridad

BM 2610011757 10-10:BM 2610011757 10-10.qxp 10/27/10 1:38 PM Page 4
Keep hands from between the blade and
material guide. Always start cut with
workpiece on the material guide. When tool
starts work will be pulled to the material
guide and can pinch your fingers.
Before starting to cut, turn tool "ON" and
allow the blade to come to full speed. Tool
can chatter or vibrate if blade speed is too
slow at beginning of cut.
Do not touch the blade or the workpiece
immediately after operation. Blade and
workpiece will be hot.
GFCI and personal protection devices like
electrician's rubber gloves and footwear will
further enhance your personal safety.
Do not use AC only rated tools with a DC
power supply. While the tool may appear to
work, the electrical components of the AC
rated tool are likely to fail and create a hazard
to the operator.
Keep handles dry, clean and free from oil
and grease. Slippery hands cannot safely
control the power tool.
Develop a periodic maintenance schedule
for your tool. When cleaning a tool be
careful not to disassemble any portion of
the tool since internal wires may be
misplaced or pinched or safety guard return
springs may be improperly mounted.
Certain cleaning agents such as gasoline,
carbon tetrachloride, ammonia, etc. may
damage plastic parts.
Ensure the switch is in the off position
before inserting battery pack. Inserting the
Before
W RNING
charger,
instructions and cautionary markings on
(1) battery charger, (2) battery pack, and (3)
product using battery.
Use only the charger which accompanied
your product or direct replacement as
listed in the catalog or this manual. Do not
substitute any other charger. Use only Bosch
approved chargers with your product. See
Functional Description and Specifications.
When removing the blade from the tool
avoid contact with skin and use proper
protective gloves when grasping the blade
or accessory. Accessories may be hot after
prolonged use.
Do not "jam" the blade or apply excessive
pressure to the tool when cutting.
Overstressing the blade increases the
loading and susceptibility to twisting or
binding of the blade in the cut and the
possibility of blade breakage.

Additional Safety Warnings

battery pack into power tools that have the
switch on invites accidents.
drilling, and other construction activities
contains chemicals known to cause cancer,
birth defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed
to filter out microscopic particles.
Battery/Charger
using battery Do not disassemble charger or operate the
read all charger if it has received a sharp blow,
been dropped or otherwise damaged in any
way. Replace damaged cord or plugs
immediately. Incorrect reassembly or damage
may result in electric shock or fire.
Do not recharge battery in damp or wet
environment. Do not expose charger to rain
or snow. If battery case is cracked or
otherwise damaged, do not insert into
charger. Battery short or fire may result.
-4-
Some dust created by power
W RNING
sanding, sawing, grinding,