Heater; Filtration - Teuco 630 Manual Del Usuario

HEATER

To switch on the minipool water heater, set the control
panel switch to "ON".
If the heater is in operation, the indicator lights up on
the control panel.
If the heater is not in operation, the control panel
indicator remains off.
The temperature is set using the selector located on
the heater.
The filter pump continues running until the water has
been heated to the set temperature.
The temperature can be set between 10 °C
and 40 °C.
Owing to the considerable amount of water in the
system, a necessarily lengthy interval of time will pass
before any change in selected temperature is sensed.

FILTRATION

There are different filtration programmes selectable, all piloted automatically by the timer at the electrical
panel.
Correct initial programming of the control panel is fundamentally important, given that filtration cycles are
programmed according to the day of the week and the time of day.
5 filtration programmes are envisaged.
Three of these programmes are intended specifically for home use, whereas the other two are recommended
for intensive use.
In general terms, all programmes include a thorough filtration cycle in the morning and in the evening.
When the pool is occupied by bathers, a condition detected automatically by the system, the filter pump will
come into operation regardless of the programme currently selected.
Similarly, the filter pump and the heater will remain in operation until the water in the pool has been heated
to the set temperature, whatever the time of day (although not during the night, in the case of home use
programmes) and the type of programme selected.
630
EN
43