Fanimation EDGEWOOD 60 Manual De Instrucciones página 10

How to Hang Your Ceiling Fan (Continued)
1. Completely remove one screw from either side of
the hanger bracket--be sure it is the screw to your
right when facing it--and keep for reinstallation on
page 12 or 13 (How to Install Your Canopy Housing
). Loosen the other two screws that were not removed.
(Figure 3)
For Downrod Fan
2. Securely attach the hanger bracket to the outlet
box using the outlet box screws and washers
supplied with the fan. (Figure 4)
WARNING
The outlet box must be securely anchored. Hanger
bracket must seat firmly against outlet box. If the outlet
box is recessed, remove wall board until bracket
contacts box. If bracket and /or outlet box are not
securely attached, the fan could wobble or fall.
3.
Using the 3/8˝ x 2˝ lag bolt and flat washer, attach
safety cable to ceiling joist or wood structural member.
The lag bolt will pass through the flat washer, safety
cable loop, and into the building structure (Figure 4).
You will first drill a 1/4˝ pilot hole into the building
structure to prevent splitting or cracking.
NOTE: Ceiling support cable cannot be secured to
outlet box only, it must be directly secured to ceiling
joist or structural member using the 3/8˝ x 2˝ lag bolt
and flat washer. (Figure 4)
4. Make sure the electrical supply wires, including the
hanger bracket grounding wire and safety cable are
pulled through the downrod, between the hanger
bracket and the outlet box so that electrical
connections can be made later.
5. Carefully lift the fan and seat the downrod/hanger
ball assembly onto the hanger bracket that was just
attached to the ceiling joist. Be sure the groove in the
ball is lined up with tab on the hanger bracket.
(Figure 5)
6.
Attach the safety cable to ceiling support cable.
Slide cable clamp onto safety cable (from fan). Place
the end of cable through the loop of ceiling support
cable. Pull as much cable through loop as possible.
Feed end of cable into clamp hole and firmly tighten
screw (Figure 5). Cut off excess safety cable.
NOTE: If you have installed your fan with the Downrod,
skip steps 7, 8, 9 and 10.
Wood Member
(2" X 4" Approx.)
Outlet
Ceiling
Box
Ceiling
Support
NOTE: SUPPLY WIRES
AND FAN WIRES OMITTED
FOR CLARITY
Downrod/Hanger
Ball Assembly
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
To avoid possible shock, do not pinch wires between
the hanger ball assembly and the hanger bracket.
10
Figure 3
Ceiling Joist
Hanger Bracket
Figure 4
Attach Safety
Cable To Ceiling
Support Cable
Tab
Figure 5
WARNING
WARNING