Ways Of Releasing Air Outdoors - BALAY 3XM170B Instrucciones De Uso

Instructions for Use
turns itself off automatically because the
thermostat trips, it is necessary to wait
for ambient temperature to rise 2-3°C
before it comes back on again.
Fig. 9
During air conditioning, some of the
condensed water produced evaporates
automatically and is expelled outdoors
together with the expelled air through the
hot air expulsion tube.
In conditions of extreme humidity, the
appliance accumulates condensed water
in an internal tank. When a certain level is
reached an indicator light, Fig. 3, comes
on indicating that the condensed water
tank is full and needs to be emptied.
When this happens, the appliance stops
cooling the air in the room until the water
is drained, as explained in "Transportation
requirements", Fig. 7.
• It is recommended that you turn the
appliance off while draining the water.
Warning!
Remember that when the appliance is
turned off and turned back on, it is
necessary to wait for approximately 3
minutes before the compressor starts
up again. This period of time is required
in order to ensure correct appliance
operation.

Ways of releasing air outdoors

Fitting the air expulsion tube and
accessories onto the appliance.
Fit the air expulsion tube assembly into the
housing on the top of the appliance at the
back, Fig. 11.
Fig. 10
In order to fit the expulsion tube assembly
properly in its housing, it is necessary to
slide the sleeve into the positioning slot (as
shown by the arrows on Fig. 12).
Fig. 12
The diffusion duct, Fig. 10, is added when
the tube assembly has been fitted onto the
appliance.
Press the "Push" ab (Fig. 13, 1.) and slide
out (Fig. 13, 2.) to remove the assembly
from the appliance.
Temporary installation
• Open the window slightly and position
the diffusion duct between the jamb and
the glaze frame.
• Close the window as far as possible and
secure it with the suction pad supplied,
Fig. 14.
Fig. 14
40
Housing for the air
expulsion assembly
Fig. 11
Fig. 13