Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Hook
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
1
2
3
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Blade rotation
The edges of the side blades can be used in four ways
by rotating the side blades as shown in the figure.
The time and procedure to rotate the side blades is as
follows:
•
When inside edges of each side blades become
rounded to about half the width, swap each side
blades.
•
When both edge of each side blades become
rounded, turn each side blades inside out.
OPERATION
Lubrication
NOTICE:
or the mineral spirits for aluminum.
Before operation, always lubricate the following areas:
A
The both sides of the center blade which contacts
to the side blade L and side blade R.
1
2
3
Adjusting cutting head angle
CAUTION:
secured in the position after adjusting the cutting
head angle. Otherwise the cutting head may rotate
during operation and cause serious injury.
Rotate the cutting head while pushing the rotation
button.
Release the rotation button when the cutting head is in
the desired angle.
► 1. Rotation button
8 ENGLISH
Use the standard machine oil for steel
A
Make sure the cutting head is
1
Tabla de contenido
