Worx WX156 Manual De Instrucciones página 9

SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Indoor use only
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return
exhausted batteries to your local
collection or recycling point.
Lithium-Ion Cordless Drill/Driver
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening screws as well as for drilling in
wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not
use another battery charger.
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit: The tool holder no longer
rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
When the battery pack is charged for the first
time and after prolonged storage, the battery
pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE THE BATTERY PACK
(See Fig. A1)
Depress the Battery Pack Release Button(6)
firmly first and then slide the Battery Pack out
from your tool.
C) TO INSTALL THE BATTERY PACK
(See Fig. A2)
Slide the fully charged Battery Pack onto the
tool with sufficient force until it clicks into
position.
OPERATION
1. ON/OFF SWITCH (See Fig. B)
Depress the On/Off switch to start and release
it to stop your drill. The on/off switch is fitted
with a brake function which stops your chuck
immediately when you quickly release the
switch.
It is also a variable speed switch that delivers
9
EN