Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Angular cutting
To adjust the slant angle, loosen the base
handle located directly below the housing
by rotating it approximately 90 degrees
and then move the groove in the semi-
circular part to the position indicated by
the mark on the gear cover.
Next, align the scale (from 0 degrees to 45
degrees in 15-degree increments) of the
semi-circular part of the base with the [ ]
mark on the gear cover, rotate the base
handle approximately 90 degrees
counterclockwise, return to directly below
the housing and tighten (Figs. 10, 11, 13,
14).
CONCERNING CUTTING OF STAINLESS STEEL PLATES
When used with the No. 95, No. 96 or No. 97 blade, can cut stainless steel plates.
Note the following to adjus the unit
CAUTION
While sawing, the base must be firmly in contact with the workpiece surface, and the
blade must be held at a right angle. If the base becomes separated from the material, it
could cause the blade to break.
When cutting stainless steel plates, adjust the unit as described below:
1. Adjust the speed......
Blade
No. 96
1/64" ~ 1/16" (0.5 mm ~ 1.5 mm)
No. 95
1/16" ~ 5/32" (1.5 mm ~ 2.5 mm)
No. 97
1/16" ~ 5/32" (1.5 mm ~ 2.5 mm)
NOTE
Dial scale reading is for reference only. The higher the speed is, the quicker the material
is cut. But the service life of the blade will be reduced in this case. When the speed is too
low, cutting will take longer, although the service life will be prolonged. Make adjustments
as desired.
2. Set the orbital position to "0" .........
NOTE
When cutting use cutting fluid (oil base cutting fluid) to prolong the blade's service life.
Thickness of material
Rectilinear
guide
Fig. 14
Dial Scale
Middle groove position
between scales "2" and "3"
English
Knob bolt
15
Tabla de contenido
