Klarstein STUDIO LIGHT & FIRE Serie Manual De Instrucciones página 20

EN
20
Installation
1. The fire is designed to be permanently
fixed to a wall at a minimum height
of 300 mm. The wall bracket must
be fitted horizontally and the cable
routed to the bottom right of the
fire. A height of 600 mm from the
floor to the bottom of the wall fire is
recommended for optimum viewing of
the fuel bed.
2. Use the bracket as a table template
and mark five drill positions on the
wall. Ensure that these holes are all
level.
3. Put the bracket aside and drill holes
with a depth of 35mm using a 2mm
pilot drill bit & 8mm drill bit.
4. Clean the holes from dust and debris
and insert one plug in each hole.
Make sure the edge of each hole is
flush with the surface.
5. Hold the bracket in position and fix it
in place with screws.
6. Carefully lift the appliance up, ensuring that the top rear ledge of wall fire engages
with the wall bracket and is sitting centrally. This process should be carried out by
two people to avoid injury or damage to property or the appliance.
7. Do not let go of the appliance until you are sure it is safely attached to the bracket.
Gently bring the wall fire down against the wall. Mark the lower fixing brackets two
fixing hole positions on the wall, then remove the wall fire.
8. Drill the wall and insert the wall plugs.
9. Refit the wall fire to the wall and fasten the bottom fixing bracket to the wall using
the screws provided to permanently fix the wall fire in place.
10. Remove the front panel and unpack the logs from the bag and place them along the
light unit in the desired position.
1 1. Put the front panel back in place.
Helpful advice before fitting
The appliance can be operated either by the switches located on the left hand side of
the fire under its canopy or by the supplied remote control.