GYS GYSPACK 660 Manual De Instrucciones página 15

Translation of the original instructions
GYSPACK 660
Product Battery
GYSPACK 660 CB28-12M
To replace the battery :
• The booster must be disconnected form the power supply.
• First the back panel must be unscrewed (19 screws) and removed.
Once the back panel is removed, the battery front appears (cf illustration). Remove the positioning belt 1 .
•
The battery is connected to the GYSPACK at two points : at the - terminal 3 and at the + terminal 2 . To
•
remove the battery, remove the 2 screws that enable the connection between the battery and the GYSPACK at the
terminals + and -.
When putting a new battery, make sure to observe the polarities of both the battery and the
GYSPACK. Terminal - on the left, terminal + on the right (cf illustration). Put the 2 screws and
washers back, tighten the nuts (recommended torque wrench 4 N.m).
• Place the booster's backpanel screws back on.
GYSPACK 660 / 750
1
Type
Lead- acid battery
Voltage (V) Capacity (Ah)
12 28
EN
2
3
Dimensions
Battery ref
(cm)
16,5 x 12,6 x 17,5 53062
15