UFESA DH4012 Manual De Instrucciones página 16

Do not use the appliance in small spaces.
Insufficient ventilation may cause
appliance overheating and result in fire.
Do not place the appliance near hot
surfaces or appliances such as tumble
dryers, heaters.
Do not use the appliance near gases
and flammable liquids, such as gasoline,
benzene, diluents, etc.
Place the appliance at least 1 m from
flammable materials.
Place the dehumidifier in a location
where the temperature does not fall
below 5°C. Lower temperature may
cause icing of the evaporator coil, leading to
a reduced appliance performance.
Do not cover or obstruct the appliance's
air inlets or outlets with fabrics, e.g.
clothes, towels, etc.
Do not place the appliance in direct
sunlight.
Do not put power cord under the carpet.
Do not place heavy items on the power
cord. Before using the appliance, make
sure that the power cord is not bent.
When the appliance has been connected,
make sure that an easy access to
a power outlet is where the appliance is
plugged in has been provided.
In order to ensure effective operation,
the appliance is to operate in a room
where good air circulation is provided.
If the appliance is placed in a basement,
it may hardly or fail to dehumidify the
adjacent space, e.g. storage unit, unless
proper air circulation around that space is
ensured.
The appliance is equipped with wheels
for moving on smooth surfaces.
Do not move the dehumidifier on carpet
or on other items.
Do not move the dehumidifier when
there is water in the tank and when the
appliance is operating.
TURN ON THE APPLIANCE
Before using, remove and re-install water
tank to properly set the float switch.
1
Plug the power cord (12) into a wall outlet.
● Make sure that the water tank (4) is properly attached.
The appliance will not operate with
missing or incorrectly attached water
tank. In this case, water tank full
indicator will light up and the display will show
P2 error code.
2
Press on/off button (F) to turn on the appliance.
The appliance turns on and the power-on indicator (G)
lights up. Display (J) shows current humidity [%].
● Set the desired air humidity by pressing the "–" (C)
or "+" (D) button (see section Normal Operation Mode).
You may also select continuous operation by pressing
continuo button (A) (see section Continuous Operation
Mode).
● The appliance starts running.
If the water tank is removed, improperly
installed or overfilled, water level control
switch turns the appliance off. In this
case, water tank full indicator will light up and
the display will show P2 error code.
B