Daga Flexyheat Air Instrucciones De Uso página 7

ENGLISH
increase the internal pressure sharply increasing the possibility of it
bursting.
This product is not intended for medical use in hospitals.
The product you purchased may only be used with the control
supplied with the product as indicated on the product label.
Materials will suffer wear and tear over time and after prolonged
use.
Carry out a regular inspection of the product including the control
and flexible cable to check for any signs of wear or damage.
Unplug the product immediately from the mains in the event of any
breakdown and contact an authorised Technical support service.
In order to prevent any risk of danger, do not open the control or
connection. Only qualified technical personnel from the brand´s
Official Technical support service may carry out repairs or procedu-
res on the device.
Any incorrect use or improper handling of the product shall render
the warranty null and void. Only an authorised technical support
service centre may carry out repairs on this product.
B&B TRENDS, S.L. disclaims all liability for damages that may
occur to people, animals or objects, for the non-observance of
these warnings.
INSTRUCTIONS FOR USE
This product can be used as a conventional pad (flat) or as a
cushion (inflating the product according to your preferences). The
level of cushioning of the product can be adjusted according to
how much it is inflated when used as a cushion. Adjust according
to your preferences and/or needs while always bearing in mind the
safety instructions contained in this instruction manual. Do not fully
inflate.
The pad should be inflated by pinching slightly with your fingers on
the base of the inflation valve until you feel the amount of air that
is being entered into the pad increasing. This technique must be
applied to release the retention valve and let the air circulate.
The product should be deflated with the valve nozzle open while
pinching slightly with your fingers on the base of the valve (as well
as during inflation), putting pressure on the surface of the pad until
all the air has been removed from its interior.
Prior to connecting the product to the mains, check your power
supply voltage to ensure it is the same as the one indicated on the
label included on the product. Connect the product to the appro-
priate mains.
In order to turn on the product, you must select the slider switch
on the control, setting it to position 1, 2 or 3 (Fig.1).
From this time on, the product is operational.
The maximum operation time is 90 minutes, after which the auto-
matic safety shut-down will immediately activate The product will
no longer heat up when in this state.
Select the " 0" position in order to turn off the product before you
disconnect the device from the mains.
Manual Flexyheat Air.indb 7
7
17/12/15 9:50