Pre-Installation - Muskoka MHC42BL Manual De Instrucciones

Pre-Installation

PLANNING INSTALLATION
Before you begin assembly, locate the instructions and hardware. Compare all parts with the Hardware Included and Package Contents lists.
Be sure you have all the parts and can identify them. A helping hand is always good. Assemble your fireplace with an adult assistant if
possible. Some pieces are heavy and will need to be held by a helper. Assembly time will take approximately 5-20 minutes.
Before assembly, use scissors to unwrap the parts from the packaging. Do not use a box cutter or exacto-knife, as you may cut into the
heater pieces inside the box and damage the finish. Check for the red hardware bag located inside the packaging, taped to the top of the
box. Do not discard any pieces. Use an appropriate screwdriver to insert and tighten all screws.
CAUTION: This carton includes a GLASS panel! Always use extreme caution when handling glass. Failure to do so could result in personal
injury or property damage.
SPECIFICATIONS
Model No .
Wall Mounted Dimensions W x D x H
Stand Mounted Dimensions W x D x H
Net Weight / Gross Weight
Voltage
Frequency
Watts / Amps
ELECTRICAL CONNECTION
WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electrical
shock, and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a qualified service technician to inspect the
fireplace and replace any part of the electrical system which has been under water.
A 15 Amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this appliance. Preferably, the appliance will be on a
dedicated circuit, as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the fireplace is in
operation. The unit comes standard with a 6 ft (1.8 m) long 3-wire cord, exiting out the back of the fireplace. Plan the installation to avoid
the use of an extension cord. Always plug heaters directly into a wall outlet/receptacle.Never use with an extension cord or relocatable
power tap (outlet/power strip).
GROUNDING INSTRUCTIONS
This heater is for use on 120 volts. The cord has a plug as shown at (A) in Figure 1.
An adapter as shown at (C) is available for connecting three-blade grounding-type
plugs to two-slot receptacles. The green grounding lug extending from the adapter
must be connected to a permanent ground such as a properly grounded outlet box.
The adapter should not be used if a three-slot grounded receptacle is available.
4
MHC42BL
42 in. x 4.4 in. x 17.4 in. (106.7 cm x 11 cm x 44 cm)
42 in. x 8.7 in. x 21.6 in. (106.7 cm x 22 cm x 54.7 cm)
40 lbs / 49.8 lbs (18.2 kg / 22.65 kg)
120V
60 Hz
1400 W / 11.7 A
(A)
METAL SCREW
COVER OF GROUNDED
OUTLET BOX
GROUNDING
PIN
ADAPTER
GROUNDING
GROUNDING
(C) MEANS
PIN
(B)
(D)