Rohde & Schwarz FPC1000 Manual Del Usario página 25

®
R&S FPC1000
Turning off the R&S FPC1000
► Turn off the main AC power switch on the rear panel of the R&S FPC1000
(position "O").
The instrument is no longer supplied with AC power.
Changing the AC supply fuse
Only fuses of the type 2A T IEC60127-2/V should be used.
1. Disconnect the power cable.
2. Open the flap covering the voltage selector using a small screwdriver (or simi-
lar).
3. Remove the cylinder labeled with the nominal voltages. Remove the fuse and
install the new one. Reinsert the cylinder so that the value visible through the
hole in the cover flap is the same nominal voltage as before.
4. Close the flap.
Getting Started 1178.4124.02 ─ 03
Turning the R&S FPC1000 on and off
Preparing for Use
10