Installation Of The Ledge Pieces And Covering Plates; Filtration - Trigano Jardin 880109 Instrucciones De Montaje Y Guía De Utilización

11. Installation of the ledge pieces and covering plates

The ledge pieces must be assembled in a certain position. The widest edge must be on the outside.
The ledge pieces must be positioned between the posts.
Each ledge piece extremity must be screwed onto a top plate or connecting plate. You may need to gently move the posts to the
left or right to install the ledge pieces. Do not fully tighten the screws until they are all in place.
Fit the covering plates over the extremities of the ledge pieces and centre them. The narrowest part of the covering plate should
be located on the inside of the pool.
1161 or 1164
Ledge piece
0341

12. Filtration

IMPORTANT: All filtration systems comply with installation standard NF
C 15-100 stipulating that all electrical devices located within 3.50 m of
the pool and freely accessible must be powered by very low voltage (12
V).
Any device powered with 220 V must be located at least 3.50 m from the
edge of the pool. This means that:
■ This means that for a filter, the device must be installed more
than 3.50 m from the pool,
■ For filtering skimmers (depending on the kit), the transformer
must be located more than 3.50 m from the pool.
NOTE: All threaded connectors should be attached with Teflon
tape, wound in the opposite direction of the thread.
Seek advice from the manufacturer for any modifications to one or more
filtration system elements.
Depending on the filter media used, refer to the quantities listed opposite
to be put in the tank.
TO ASSEMBLE THE FILTER SYSTEM, REFER TO THE USER GUIDE IN THE FILTRATION BOX
VARUNA-SAPHIR-CANYON Round
2463
Ledge piece covering plate
(Round part)
2464
69
2402
0341
Discharge
nozzle
Filtration size Sand
Filtration 4 m³/h 20 kg
Filtration 6 m³/h 35 kg
Filtration 8m³/h 75 kg
Filtration 10 m³/h 75 kg
Filtration 12 m³/h 75 kg
0341
Skimmer
Aqualoon ball
560 g
980 g
2100 g
2100 g
2100 g
Guide 880109-rev A