Reiner B2 Manual De Instrucciones página 4

GB
To set the stamp wheels
Press the handle
travel, then while still holding it.
Press and hold button
Allow the handle
the handle locks in place.
You will be able to move the stamp wheels
freely with the stylus
You can hide preceding zeros in a number!
Example:
49
Turn the stamp wheel
digit position "0".
Using stylus rotate and push down on
stamp wheel through a half digit
position until it sinks below print height.
To return to the print position, simply push
down on handle
Any wheel which has been 'sunk' will
automatically be brought to print height
as the numbering sequence progresses.
'Sunk' wheels can be brought into play
by simply rotating them further
(ie. push towards figure 1.).
To insert the inkpad
Note: Use only oil-containing stamp ink.
Handle with caution to avoid dirt from ink!
Press the handle
travel, then, while still holding it.
Press the button
continue to hold it pressed.
1 2
Fig. +
to the bottom of its
on the front plate.
to move upwards until
.
instead of 000049
with stylus to
.
1 3
Fig. +
to the bottom of its
on the front plate and
Allow the handle
the handle locks in place.
Unpack the inkpad carefully.
Squeeze the grips
inkpad and hold them.
Resting the back of the ink pad inside the
pad cradle slide the pad into the slot
the stamp.
In order to return to the print position,
simply push down on handle
To change the numbering actions
Actions
0
The same number is stamped every time.
1
Number increases after each stamping
process.
2
Number increases after every 2
stamping process.
etc.
Raise the Action selector lever
it to the desired action.
To park the stamp
To prolong the life of the inkpad,
park the stamp!
Press and hold button
Gently push handle
stamp clicks & locks in a raised position.
In order to return to the print position,
simply push down on handle
GB
to move upwards until
on the back of the
of
.
Fig.
nd
and move
5
Fig.
on the front plate.
downwards until the
.
4