Moving Your Appliance; Cleaning And Maintenance - Domo DO984RKMG Manual De Instrucciones

Frigorífico, congelador
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 47

MOVING YOUR APPLIANCE

If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This
will allow the refrigeration system pressures to equalise before restarting.
· Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove
all mobile parts (shelves, accessories, etc.) or fix them into the fridge to avoid any shock.
· Relocate and install. If the appliance has been left on its side for any length of time, leave it
standing upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally
friendly and natural gas, it is explosive. Therefore you should be careful during shipment and
installation to prevent your appliance's cooler elements from being damaged. In the event of
a leak caused by damage to the cooler elements, move your fridge from open flame or heat
sources and ventilate the room where the appliance is located for a few minutes.

CLEANING AND MAINTENANCE

CLEANING
Do not use abrasive cleaning agents or solvents.
1.
Set the temperature control knob to the "0" position and disconnect the mains plug from
the mains socket.
2.
Take out the food and store in a cool location.
3.
Clean the appliance with a soft cloth, warm water and detergent.
4.
Wipe the door seal with clear water only and then wipe dry thoroughly.
5.
After cleaning reconnect and adjust the temperature control knob as desired.
6.
Put the food back into the appliance.
DEFROSTING THE FRIDGE
The refrigerator defrosts fully automatically. While the
cooling is running, beads of condensation or hoarfrost
form at the back of the refrigerator. This is normal. It is not
necessary to wipe off the condensation or frost. The rear
panel defrosts automatically. The condensation runs into
the condensation channel and is conveyed to the cooling
from where it evaporates.
Note: Keep the condensation channel and drainage hole
clean, so that the condensation can run out.
44
DO984RKMG
Tabla de contenido
loading

Tabla de contenido