Tabla de contenido
Idiomas disponibles
Idiomas disponibles
cod. 99008
the fixed board(4) and protection guard under cover (5).
Warning! Use only original manufacturer's replacement parts, accessories and attachments. Failure
to do so can cause poor performance, possible injury and may void your warranty.
Never use the machine without the guard assembled!
7. Assemble the cutting head.
3.4 Release the nut. Line up the two holes of flange and shield, use one hex key to hold the
flange as below and turn the socket wrench clockwise, the nut will be released.
3.5 Fit the Nylon cutting head. Remove another shield after release the nuts as picture showing.
Still hold the flange, take the Nylon cutting head on the shaft and rotate counter-clockwise,
the Nylon cutting head is fitted.
3.6 Release the Nylon cutting head. Use screw driver to hold the flange and then rotate the
Nylon cutting head clockwise, it will be replaced.
Warning!
20
Tabla de contenido
