Maintenance - RedMax BCZ2650S Manual De Instrucciones

BCZ2650S/T/SS

9. Maintenance

Maintenance, replacement, or repair of the emission control device and
systems may be performed by any non-road engine repair establishment or
individual.
■ MAINTENANCE CHART
system/compornent
fuel leaks, fuel spillage
fuel tank, air filter, fuel filter
idle adjusting screw
spark plug
cylinder fins, intake air cooling vent
muffler, spark arrester, cylinder exhaust port clean
throttle trigger, stop switch
cutting parts
cutting attachment guard
angle transmission
screws/nuts/bolts
MA1
US-14
every
procedure before hours
use after
✔
wipe out
✔
inspect/clean
see ■ADJUSTING
✔
IDLING SPEED (p.12)
clean and readjust
plug gap
clean
✔
check operation
replace if
✔
something's wrong
✔
make sure to attach
grease
✔
tighten/replace
every every
25 50 100
hours hours note
after after
✔
replace, if necessary
replace carburetor
if necessary
GAP: .025in (0.6~0.7mm)
✔
replace, if necessary
✔
✔
✔
✔
not adjusting screws
■ REFILLING TRIMMING LINE (MA1)
1. For replacement line, use a diameter of .095in (2.4mm). The
spool is capable for a line upto 20ft (6m) on the 4" head. Avoid
using a larger line as it may cut down the trimming performance.
WARNING
For safety reasons, do not use metalreinforced line.
2. Pinch the slotted area on the both sides of the spool housing to
unhook the bottom cap.
3. Take out the spool and pull off the old line. Fold new line so that
one half line is 4.7in.(12cm) shorter than another half. And then,
hook bended end in the slot of the spool.
4. Wind up the line in the correct direction as indicated on the
spool.
5. Hook each end of the line in the slot on the edge of the spool,
and then put the ends through the eyelets on the housing. Make
sure that the spring and the washers are in place.
6. While holding the spool against the housing, pull the line ends to
release them from the slot.
7. Line up the slot on the bottom cap with the hook on the housing,
press the cap against the housing until it clicks.