Operation - Glacier bay HD67495-1008D2 Guía De Instalación Y Cuidado

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks. Do not lose
the gasket (1) in the hose.
□
Pull the hose assembly out of the spout and
remove the spray head by unscrewing it from
the hose in a counterclockwise direction. Be
sure to hold the end of the hose down into the
sink and turn the faucet to the warm position
where it mixes hot and cold water.
□
Flush the water lines for one minute. This ushes
away any debris that could cause damage to
internal parts. Check for leaks.
□
Re-tighten any connections if necessary, but do
not overtighten. Reinstall the spray head by hand
tightening it back onto the spray hose in a
clockwise direction.
2
Operating the sensor
NOTE: The sensor is active only when the handle is in the
ON position.
□
Turn the handle (1) away from the faucet to the
full on position. Turn the water on by activating
the sensor (2) by waving your hand within
2-3/8 inches of the sensor.
□
Move handle towards you and away from you,
the water ow pattern can be switched from
the cold water to hot water.
□
If the sensor does not work, then you can refer
to the troubleshooting. If you want to use the
faucet without the sensor feature, then you
can refer to step 6. Then, turning on the water
can be done by moving the handle away from
the faucet to the full on position.
NOTE: As a water saving feature, the water will turn off
automatically after 3 minutes of continuous ow.
0
1
min.
45
15
30
1
0
3
min.
45
30
2
2-3/8 in. MAX
12
15
Cold
1
Hot