Operation; Care And Cleaning; Troubleshooting - Glacier bay 67557-0008D2 Guía De Instalación Y Cuidado

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
□
Remove the spray head by unscrewing it from
the hose in a counterclockwise direction, turn
the faucet to the warm position where it mixes
hot and cold water.
□
Flush the water lines for one minute. This ushes
away any debris that could cause damage to
internal parts. Check for leaks.
□
Re-tighten any connections if necessary, but do
not overtighten. Reinstall the spray head tightly.

Care and Cleaning

□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.

Troubleshooting

NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks
underneath the handle.
The aerator leaks or has
an inconsistent water
ow pattern.
The water pressure is low. The aerator is clogged.
There is no hot or cold
water.
Possible Cause
The bonnet nut has come loose and the
o-ring on the cartridge is dirty or damaged.
The aerator is dirty or mis tted.
The cartridge may be clogged.
The water inlet hose was acccidentally
kinked during installation and is limiting
the water ow through.
□
□
□
□
□
□
□
□
□
16
Please contact 01-800-00-4663-3 for further assistance.
Solution
Tighten the bonnet nut. Clean
or replace the o-ring.
Remove the aerator and check
for debris in the aerator screens.
Remove the cartridge and check
for debris.
Ensure the aerator is properly
installed.
Turn off the water supply and
disconnect the aerator.
Unscrew the aerator and clean
under running water.
Screw the aerator back.
Test water ow. If water
pressure is still low then replace
the aerator.
Reinstall the water inlet hose.
HOMEDEPOT.COM.MX