Fanimation The Torto FP7902 Serie Manual Del Propietário página 7

How to Assemble Your Ceiling Fan (
3. Loosen the two setscrews in the Downrod Support.
Align the Clevis Pin holes in the Downrod with the holes
in the Downrod Support. Install the Clevis Pin and secure
with the Hairpin Clip. (Figure 2) Be sure to push the
straight leg of the hairpin clip through the hole near the
end of the clevis pin until the curved portion of the hairpin
clip snaps around the clevis pin. The hairpin clip must be
properly installed to prevent the clevis pin from working
loose. Pull on the Downrod to make sure the clevis pin is
properly installed. Tighten the two set screws and locking
nuts in the downrod support.
4. Slide the Motor Coupling Cover down until it touches
the top of the Housing. (Figure 3)
5. Route wires through Motor Coupling Cover andthrough
opening in CanopyScrew Cover and Canopy. Position
CanopyScrew Cover and Canopy on fan shown with
open side facing up. (Figure 3)
6. Reinstall the Hanger Ball (Figure 1) on the Downrod
as follows. Route the three 80" wires through the
Hanger Ball. Position the Pin through the two holes in the
Downrod and align the Hanger Ball so the Pin is captured
in the groove in the top of the Hanger Ball. Pull the Hanger
Ball up tight against the pin. Securely tighten the
setscrew in the Hanger Ball. A loose setscrew
could create fan wobble.
▲WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
7. Install the three blades making sure the bottom edge of
each blade seats in the external flange of the motor
housing (see Blade Mount Detail). Align the 3 holes on
top of each blade and the motor housing and securely
tighten the screws (3 per blade) provided. (Figure 4)
8. Before installing fan, measure up approximately 6-9
inches above top of Downrod/Hanger Ball Assembly. Cut
off excess wire and strip back insulation 1/2" from end of
wire.
9. You have now completed the assembly of your ceiling
fan. You can now proceed with the hanging and the
electrical wiring of your fan.
NOTE:
All set screws must be checked and re-tightened
where necessary before installation. (See Maintenance,
page 13)
Hairpin Clip
Clevis Pin
Canopy
Canopy
Screw
Cover
7
Continued)
Motor
Coupling
Cover
Set Screws and
locking nuts (2)
Figure 2
Motor
Coupling Cover
Figure 3
Blade
Bottom
Edge of
Blade
Seated in
Motor
Housing
Flange
Blade Mount
Detail
Figure 4