Installing The Canopy Housing; Final Fan Assembly - Fanimation The Torto FP7902 Serie Manual Del Propietário

NOTE: This step is applicable after the necessary wiring
is completed.
▲WARNING
To avoid possible fire or shock, make sure that the
spliced electrical wires are turned upward and completely
pushed carefully up into the junction box and not pinched
between the housing and the ceiling.
1. Remove the two shoulder screws in the Hanger Bracket
with a screwdriver. Securely attach the Canopy Housing
with the shoulder screws provided and then tighten the
screws (Figure 1a).
2. Securely attach the Canopy Screw Cover over the
shoulder screws in the Hanger Bracket utilizing the keyslot
twist-lock feature (Figure 1b).
CAUTION
To avoid possible electrical shock, be sure electricity is
turned off before installing downlight assembly.
Remove one of the three screws in the support
1.
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws. (Figure 1)
2. Connect the 2 single-pin connectors from the light
plate assembly to the 2 single-pin connectors from the
motor assembly. (Figure 2)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.

Installing the Canopy Housing

Final Fan Assembly

10
Figure 1a
Figure 1
Motor
Assembly
Figure 2
Figure 1 b
Light Plate
Assembly