How To Install Your Remote Control; Maintenance; Trouble Shooting - Fanimation The Torto FP7902 Serie Manual Del Propietário

1. Installing Wall Plate: (Figure 1)
Attach wall plate using the two provided screws.
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the fi nish.
Abrasive cleaning agents are not required and should be
avoided to prevent damage to fi nish.
RECOMMENDED:
secure.
For your own safety TURN OFF power at fuse box or circuit breaker before trouble shooting your fan.
Trouble
1. FAN WILL NOT START
2. FAN SOUNDS NOISY
3. FAN WOBBLES
EXCESSIVELY
4. NOT ENOUGH AIR
MOVEMENT

How to Install Your Remote Control

Periodically check that the fan motor unit, blades and light kit screws are tight and

Trouble Shooting

Probable Cause
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan, or loose
switch wire connections in the switch housing.
3. Dead battery in remote control.
1. Motor noise caused by solid state variable speed
control.
1. Setscrew in downrod support is loose.
2. Setscrew in downrod/hanger ball assembly is loose.
3. Hanger bracket and/or ceiling outlet box is not
securely fastened.
4. Fan blades out of balance.

Maintenance

Do not use water when cleaning your ceiling fan. It could
damage the motor or the finish and create the possibility
of electrical shock.
▲WARNING
13
Figure 1
CAUTION
Suggested Remedy
1. Check main and branch circuit fuses or circuit
breakers.
2. Check line wire connections to fan and switch wire
connections in the switch housings.
CAUTION: Make sure main power is turned off !
3. Replace with fresh battery.
1. Some fan motors are sensitive to signals from
solid-state variable speed controls. Solid-state controls
are not recommended, choose an alternative control
method.
1. Tighten both setscrews securely in downrod support.
2. Tighten the setscrew in the downrod/hanger ball
assembly.
3. T ighten the hanger bracket screws to the outlet box,
and secure outlet box.
4. Balance blades using balance kit provided in
hardware bag.
1. If possible, consider using a longer downrod (not
included, you can buy the longer downrod from
fanimation.com).