Makita HM1213C Manual De Instrucciones página 7

009951
Disconnect the connector by pulling them.
1
2
009950
Loosen the four screws on crank cap and remove the
crank cap cover.
2
009952
Wipe out the old grease inside and replace with a fresh
grease (60 g). Use only Makita genuine hammer grease
(optional accessory). Filling with more than the specified
amount of grease (approx. 60 g) can cause faulty
hammering action or tool failure. Fill only with the
specified amount of grease.
009953
CAUTION:
Be careful not to damage the connector or lead
•
wires especially when wiping out the old grease.
1. Screws
1
1. Connector
2. White
3. Black
3
1. Screwdriver
2. Crank cap cover
1
1. Grease
1
To reassemble the tool, follow the disassembling
procedure in reverse.
CAUTION:
Do not tighten the crank cap excessively. It is made
•
of resin and is subject to breakage.
1
2
009954
Connect the connector firmly and then reinstall the
handle.
CAUTION:
Be careful not to damage the connector or lead
•
wires especially when installing the handle.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point (SDS-max)
•
Cold chisel (SDS-max)
•
Scaling chisel (SDS-max)
•
Clay spade (SDS-max)
•
Bit grease
•
Safety goggles
•
Hammer grease
•
Plastic carrying case
•
7
1. Connector
2. White
3. Black
3
or attachments
Only use accessory or
are