Tabla de contenido
NOTE: References to right or left side of the snow thrower are determined from
behind the unit in the operating position (standing directly behind the snow
thrower, facing the handle panel).
Removing From Carton
1.
Cut the corners of the carton and lay the sides flat on the ground. Remove
and discard all packing inserts.
2.
Move the snow thrower out of the carton.
3.
Make certain the carton has been completely emptied before discarding it.
Assembly
1.
Place the shift lever in the Forward-6 position.
2.
Observe the lower rear area of the snow thrower to be sure both cables are
aligned with roller guides before pivoting the handle upward. See Figure 1.
NOTE: Make certain the upper ends of each cable are seated properly in its
bracket.
3.
Secure the handle by tightening the plastic wing knob located on both the
left and right sides of the handle. See Figure 2. Remove and discard any
rubber bands, if present. They are for packaging purposes only.
ASSEMBLY
8
Figure 1
Figure 2
Capítulos
Tabla de contenido
Solución de problemas
