Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Use non-slip, heavy-duty protective gloves when operating
the shrubber and when installing or removing blades.
Replace any blade or other parts that are cracked or
damaged. Always make sure blade is installed correctly
and securely fastened before each use. Failure to do so can
cause serious personal injury to the operator, bystanders,
or damage to the unit.
Never cut any material over 3/8 in. diameter.
Maintain a firm grip on handle while cutting with a blade.
Keep the blade away from body.
Know how to stop the unit quickly in an emergency.
Check damaged parts. Before further use of the shrubber,
a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and
perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts,
mounting, and any other condition that may affect its
operation. A guard or other part that is damaged should
be properly repaired or replaced by an authorized service
center unless indicated elsewhere in this manual.
Install the padlock (not included) or lock-out pin into
the switch before making any adjustments, changing
accessories, or storing the shrubber. Such preventive
safety measures reduce the risk of starting the product
accidentally.
Service on the product must be performed by qualified
repair personnel only. Service or maintenance performed
by unqualified personnel could result in injury to the user
or damage to the product.
Always stop motor and install padlock (not included) or
lock-out pin into switch when not in use, before attempting
to remove any obstruction caught or jammed in the blade,
and before removing, installing, or making any blade
adjustments.
Battery powered units do not have to be plugged into an
outlet; therefore, they are always in operating condition.
Be aware of possible hazards even when the unit is not
operating.
NEVER attempt to change the cutting attachments without
first padlocking (not included) the switch or installing the
lock-out pin into the switch.
SPECIFIC SAFETy RULES
Page 5 — English
Never use shrubber if the switch will not turn the unit on
or off. A unit that cannot be controlled by the switch is
dangerous and must be repaired before use.
Shrubber is for cutting hedges and shrubbery only. Do
not use for any other purpose.
Maintain shrubber with care. Keep cutting edge sharp
and clean for best performance and to reduce the risk
of injury. Follow instructions for lubricating and changing
accessories. Keep handles dry, clean, and free from oil
and grease.
Battery tools do not have to be plugged into an electrical
outlet; therefore, they are always in operating condition.
Be aware of possible hazards when not using your battery
tool or when changing accessories. Following this rule will
reduce the risk of electric shock, fire, or serious personal
injury.
Do not place battery tools or their batteries near fire or
heat. This will reduce the risk of explosion and possibly
injury.
Do not crush, drop or damage battery pack. Do not
use a battery pack or charger that has been dropped or
received a sharp blow. A damaged battery is subject to
explosion. Properly dispose of a dropped or damaged
battery immediately.
Batteries vent hydrogen gas and can explode in the
presence of a source of ignition, such as a pilot light.
To reduce the risk of serious personal injury, never use
any cordless product in the presence of open flame. An
exploded battery can propel debris and chemicals. If
exposed, flush with water immediately.
For best results, your battery tool should be charged in a
location where the temperature is more than 50°F but less
than 100°F. To reduce the risk of serious personal injury,
do not store outside or in vehicles.
Save these instructions. Refer to them frequently and use
them to instruct others who may use this tool. If you loan
someone this tool, loan them these instructions also to
prevent misuse of the product and possible injury.
Tabla de contenido
