NuTone PUREPOWER Serie Guia De Instalacion página 20

CI377W CANSWEEP

Fig. A
Solvent weld a coupling
to a piece of 2" central
vacuum pipe, long enough
to reach the 4" x 4" access
hole from the opening on
the kick plate (Fig. A).

Insert the
CanSweep ® /pipe
into the opening on
the kick plate.
Use a 90° sweep
elbow fitting to
determine a cut
mark on the other
end of the pipe.
Then cut the pipe
at the mark.

Slide the
low voltage wires
into the
®
CanSweep clips
as shown to
complete the wiring
connections.

Slide the
®
CanSweep /pipe
and low voltage
wires into the
opening on
the kick plate. Glue
both ends of the
elbow to the piping
system, and then
secure the
®
CanSweep to the kick plate with the 2 supplied screws.
UNDER CABINET INSTALLATION (
®
Fig. B
Friction fit the other end
of the coupling to the
®
CanSweep until secure.
Do not glue, friction fit only
(Fig. B).
Glue elbow
to pipe
Screws
20
' )
CONT D