Tool Specifications - Bostitch SB-150SX Manual De Operación Y De Mantenimiento

TOOL SPECIFICATIONS

All screws and nuts are metric.
MODEL
SB-1842BN
SB-1850BN
SB-150SX
SB-1664FN
SB-125BN
SB-2IN1
FASTENER SPECIFICATIONS:
TOOL MODEL
SB-125BN
SB-1842BN
SB-1850BN
SB-2 IN 1
TOOL MODEL
SB-150SX
SB-2 IN 1
TOOL MODEL
SB-1664FN
TOOL AIR FITTING:
These tools use a free-flow connector plug, 1/4 N.P.T. The inside diameter should be
.200" (5mm) or larger. The fitting must be capable of discharging tool air pressure when
disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm
best fastener performance.
DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
OPERATION
BOSTITCH OFFERS TWO TYPES OF OPERATION.
CONTACT TRIP
The common operating procedure on "Contact Trip" tools is for the operator to contact the work to actuate
the trip mechanism while keeping the trigger pulled, thus driving a fastener each time the work is
contacted. This will allow rapid fastener placement on many jobs, such as sheathing, decking and pallet
assembly. All pneumatic tools are subject to recoil when driving fasteners. The tool may bounce, releasing
the trip, and if unintentionally allowed to recontact the work surface with the trigger still actuated (finger
still holding trigger pulled) an unwanted second fastener will be driven.
SEQUENTIAL TRIP
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This
makes accurate fastener placement easier, for instance on framing, toe nailing and crating applications.
The Sequential Trip allows exact fastener location without the possibility of driving a second fastener on
recoil, as described under "Contact Trip". The Sequential Trip Tool has a positive safety advantage because
it will not accidentally drive a fastener if the tool is contacted against the work – or anything else – while
the operator is holding the trigger pulled.
MODEL IDENTIFICATION:
Refer to Operation Instructions on page 9 before proceeding to use this tool.
CONTACT
TRIP
Identified by:
BLACK
TOOL ACTUATION
Sequential Trip
Sequential Trip
Sequential Trip
Sequential Trip
Sequential Trip
Sequential Trip
BRAD SERIES GAUGE
BT1300 18
BT1300 18
BT1300 18
BT1300 18
STAPLE SERIES CROWN WIDTH
SX5035 5-6mm
SX5035 5-6mm
NAIL SERIES GAUGE
SB16 16
2 ). Select the operating pressure within this range for
SEQUENTIAL
TRIP
Identified by:
GRAY
LENGTH HEIGHT
9.25" 8.5"
9.25" 9.5"
9.50" 8.75"
11.25" 11.50"
9.25" 8"
9.25" 8.5"
FASTENER RANGE
5/8" - 1-1/4"
5/8" - 1-5/8"
5/8" - 2"
5/8" - 1-5/8"
FASTENER RANGE
1/2" - 1-1/2"
1/2" - 1-1/2"
FASTENER RANGE
1" - 2-1/2"
-4-
WIDTH WEIGHT
2" 2.38 lbs.
2" 2.69 lbs.
2" 2.65 lbs.
3" 4.03 lbs.
2" 2.12 lbs.
2" 2.38 lbs.