Tabla de contenido
6159948210_07
Series: C
● Re-fit the circlip (20) and re-position the
O-Ring on the cylinder.
Warning: when reassembling the turbine
in the motor housing, adjust the turbine
slot in line with the housing pin. Push
the turbine to the bottom, then screw the
plug (30) again, using the pin wrench
(drawing D). Tighten to a 30 Nm torque
and glue it.
Disassembling and reassembling the
crankpin
● Using a small screwdriver, pull out the retainer
ring (34) laterally and using the extractor
(drawing F), take out the crankpin/ bearing
assembly (integral assembly).
● Slightly lubricate the crankpin (33) bearing
with Bardall HR160 and re-fit the assembly on
the eccentric shaft (32).
● Slip the retainer ring (34) sideways, then,
using a small screwdriver, lock one side of
the retainer ring in the groove and slide it to
the bottom of its housing, using a second
screwdriver (check the correct position of the
retainer ring in the groove).
Changing the sleeves
● The sleeve is clipped on.
Disassembling and reassembling the plug
valve
● Remove the handle (1), the sleeve, the
sanding pad and the collector (3).
● Using a Ø2 mm punch, push the pin (13)
downward to extract it and remove the plug
valve (14).
● When reassembling, slip the pin flush with the
motor housing, checking the correct position
of the plug valve in its housing.
Changing the sanding pad
● Place the plug valve (14) in closed position
before changing the sanding pad.
12 / 76
English
08/2015
Tabla de contenido
