Installing The Canopy Housing; Assembling And Mounting The Fan Blades - Fanimation Islander MAD3250 Serie Manual Del Propietário

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

NOTE: This step is applicable after the necessary wiring

is completed.

WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy housing

and not pinched between the housing and the ceiling.

1. Remove one of the two shoulder screws in the

hanger bracket. Loosen the second shoulder screw

without fully removing it. Assemble canopy by

rotating key slot in canopy over shoulder screw in

hanger bracket. Tighten shoulder screw. Fully

assemble and tighten second shoulder screw that

was previously removed (Figure 14a).

2. Securely attach and tighten the canopy screw cover

r e

h t

d l

r e

c s

the keyslot twist-lock feature (Figure 14b).

Assembling and Mounting the Fan Blades

1. Lay flat side of blade holder arm on a flat surface

with the inside of the blade holder arm facing up.

This is the side with the threaded posts and pitched

foot. Position the blade over the blade holder with

the threaded posts showing. Make sure the bottom

edge of the blade is fully seated against the blade

holder arm. Place blade holder cover on top of the

blade, positioning the holes over the threaded posts.

With a Philips screwdriver, thread both screws into

the posts but do not fully tighten.Prior to final

tightening, position the centerline of the blade holder

with the center of the end of the blade. Tighten both

screws to secure the blade. (Figure 15)

NOTE: You will find the fan blade set packed in its own

carton and the blade holders and hardware bag in the

fan box.

Do not connect fan blades until the fan is completely

installed. Installing the fan with blades assembled

may result in damage to the fan blades.