Stihl FS 100 RX Manual De Instrucciones página 26

Ocultar thumbs Ver también para FS 100 RX:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

English
Hold the starter grip with your right
N
hand.
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Crank the engine until it begins to
N
fire. After no more than five
attempts, turn the choke knob to e.
Continue cranking.
N
As soon as the engine runs
Blip the throttle trigger. The slide
N
control moves to the normal run
position F – and the engine settles
down to idle speed.
Make sure the carburetor is correctly
adjusted. The cutting attachment must
not rotate when the engine is idling.
Your machine is now ready for
operation.
24
Shut off the engine.
Push the slide control in the
N
direction of the arrow on the stop
symbol (h) to STOP-0.
At very low outside temperatures:
As soon as the engine runs:
Blip the throttle trigger to disengage
N
the starting throttle position. The
slide control moves to the normal
run position (F) – and the engine
settles down to idle speed.
Open the throttle slightly.
N
Warm up the engine for a short
N
period.
If the engine does not start
Choke knob
If you did not turn the choke knob to e
quickly enough after the engine began to
fire, the combustion chamber is flooded.
Turn the choke knob to e.
N
Set the slide control, lockout lever
N
and throttle trigger to the starting
throttle position.
Start the engine by pulling the
N
starter rope briskly – 10 to 20 pulls
may be necessary.
If the engine still does not start
Move the slide control to STOP-0.
N
Remove the spark plug – see
N
"Spark Plug".
Dry the spark plug.
N
Crank the engine several times with
N
the starter to clear the combustion
chamber.
Refit the spark plug – see "Spark
N
Plug".
Move the slide control to START.
N
Set the choke knob to e – even if
N
the engine is cold.
Now start the engine.
N
Throttle cable adjustment
Check adjustment of throttle cable –
N
see chapter on "Adjusting the
Throttle Cable".
Fuel tank run until completely dry
After refueling, press the fuel pump
N
bulb at least five times – even if the
bulb is filled with fuel.
Set the choke knob according to
N
engine temperature.
Start the engine.
N
FS 100 RX

Capítulos

Tabla de contenido
loading

Tabla de contenido