Pressure Washer Rinsing; Automatic Cool Down System (Thermal Relief) - Briggs & Stratton BRUTE 2500 PSI Manual Del Operario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

5. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump. Turn on water.
NOTICE
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Engage trigger lock on spray gun and start engine
following instructions How to Start Your Pressure
Washer.
7. Rotate detergent shut-off valve on cleaning tank to "On"
position (A).
8. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
9. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as needed to prevent
surface from drying. DO NOT allow detergent to dry on
(prevents streaking).
14

Pressure Washer Rinsing

For Rinsing:
1. Engage trigger lock on spray gun.
2. Make sure detergent shut-off valve is in "Off" position.
3. Slide the nozzle backward to high pressure, press the
trigger and wait for the detergent to clear.
4. Keep the spray gun a safe distance from the area you
plan to spray.
Kickback from spray gun can cause you to fall.
• Operate pressure washer from a stable surface.
• Be extremely careful if you must use the pressure washer from
a ladder, scaffolding, or any other similar location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
A
5. Apply a high pressure spray to a small area, then check
the surface for damage. If no damage is found, it is
okay to continue cleaning.
6. Start at the top of the area to be rinsed, working down
with same overlapping strokes as you used for washing
and applying detergent.

Automatic Cool Down System (Thermal Relief)

If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F (51°C). The system engages to cool the pump by
discharging the warm water onto the ground.
WARNING
www.brutepower.com

Capítulos

Tabla de contenido
loading

Tabla de contenido