Broan FRESH IN PREMIUM FIN-180P Instrucciones De Instalación página 16

Risk of electric shock. Before performing any maintenance or servicing, always
disconnect the unit from its power source or turn power off at service panel. Some
troubleshooting steps (boxes in light grey) require the unit to be powered while being
manipulated; beware of live and moving parts at all times.
7.2 FIN-180P-HW T
FIN-180P-HW
unit does not work
YES
Does the LED on the
electronic board blink?
YES
Refer to appropriate
error code according to
LED blinking.
Replace the
NO
electronic
board.
⚠
ROUBLESHOOT
Open the door, set the Run
time % button to "Test".
Does the LED on the
electronic board light up?
(The LED is located right next
to the sensor. Refer to
Section 2, step 6. The
electrical compartment does
not have to be opened.)
Turn power on
NO
at service panel.
Does the motor
start? star
YES
The unit is working but
was in a standby period.
This Supply Fan is
designed to provide fresh
air at the best time of the
day.
Turn the Runtime %
button at any setting
other than "Test" for at
least 5 seconds. Turn the
button back to "Test" and
wait 15 seconds.
Use a voltmeter. Is there
120 VAC on J2?
YES
Make sure that no Make su
debris is blocking
the motor. If there
is, remove it,
otherwise replace
the motor.
WARNING
Use a voltmeter. U
NO
Is there
2 24 VAC between
R and C.
NO
Verify that the R and C Verify th
connections are adequate
and that the low voltage
source is powered.
Is there power
NO
.
coming from service c
panel?
YES
Are the wire connections
coming from house
power cable secured
properly? Are the J1, J2
and J10 connectors well
connected to the board?
YES
Turn power on at
YES
service panel. Use a
voltmeter. Is there
120 VAC between
the white wire of J1
and both sides of
the fuse?
NO
Use a voltmeter. Is
there 120 VAC on
NO
The h The house power
cable may be
defective. Refer to
an electrician.
16
.
YES
Replace the
electronic
n
NO
Check for tripped
e
circuit breaker.
NO
co connections.
YES
Replace the
J1?
board.
Restore
electronic
board