Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
ATTACHING FIREBOX TRIMS
Attach the top trim piece with the screws provided. Please
refer to the detailed instructions that come with the mantel
that you purchased.
Operation
The firebox main power "on/off" switch must be switched "on" before any of the control functions, (on the
firebox and/or remote control) will operate. NOTE: The main switch does not have to be turned off when the
firebox is not being used for brief time periods. If however, you are not planning to use your firebox for extended
time periods or going away on vacation, we recommend the main power "on/off" be switched off.
This firebox insert features conveniently separate controls for the flame effect and heat control.
This feature allows you to operate the unit in 2 different ways;
• As a full featured fireplace insert with both flame effect and heater operating simultaneously.
• As a visual effect with flame effect only. (i.e. no heating cycle)
NOTE: This firebox insert is not designed to operate in "heat" only mode without a flame effect.
All of the firebox control functions can be accessed in 2 ways:
USING THE REMOTE CONTROL
1. ON/OFF: (The master power switch must be "on")
Press the "on/off" button on the remote control, the flame effect
(only) will turn on. To turn the firebox "off" press the "on/off" button
again.
2. FLAME EFFECT: Press the flame "+" or flame "–" button to achieve
the desired effect. (no heat)
3. HEATING: Press the heat button "once" for "low" and/or "twice"
for "high" to achieve the desired level. (NOTE: the flame effect
is always active when the heating cycle is operational) Press the
button a "third" time turns the heating cycle off.
4. ACCENT LIGHTING: Allows you to create mood and highlight the
simulated brick refractory inside your firebox. Low, medium, high,
off.
USING THE MANUAL CONTROLS
(located on the firebox behind the upper front access panel)
1. ON/OFF: (The master power switch must be "on") Press the
"on/off" button on the touchpad, the flame effect (only)
will turn on. To turn the firebox "off" press the "on/off" button
again. (NOTE: The "on/off" button on the touchpad does "not"
control the master power "on/off" switch)
2. FLAME EFFECT: Press the flame "+" or flame "–" button to
achieve the desired effect. (no heat)
3. HEATING: (See details above under Remote Control)
4. ACCENT LIGHTING: (See details above under Remote Control)
6
x3
1
4
3
2
Capítulos
Tabla de contenido
