Care; Operation; Service - EdenPURE Signature Manual De Funcionamiento Y Garantía

Care • Operation • Service
READ ALL INSTRUCTIONS BEFORE USING THE HEATER
Operation – 12 step set-up for EdenPURE
1) Unpackage heater. Cut open tape area, fold back flaps and gently turn entire
box upside down. Lift box from styrofoam packing. Remove styrofoam, turn
upright. We recommend keeping the packaging for off-season storage and any
transporting needs.
2) Find a level and unobstructed location to place the unpackaged heater.
3) Plug the power cord directly into an unused grounded 110 volt 15 amp or higher
circuit receptacle. The power switch will illuminate and the heater will beep 3
times indicating the unit is plugged into the receptacle.
4) Insert 2 "AAA" batteries into the battery compartment on the remote control.
5) Push the "Power" button located on the front of the heater or the remote control to
turn the heater on. Set the Mode Key to "Auto". Adjust the "temp up" and "temp
down" buttons until the desired temperature is reached. Once the desired
temperature is reached the heater will cycle on and off to maintain the room
temperature. When the Signature Model is set on the "Auto" mode and cycling off
and on, it has been equipped with an Energy Savings feature. The unit will run on
full power until it gets to within 2 degrees of the desired temperature. At this point
it will automatically go into an energy savings mode which shuts down 2 of the
heating elements and lowers the fan speed. Not only will this save energy, it also
keeps the room temperature closer to the desired temperature. The fan will run
periodically to circulate the room air through the heater in order to monitor the
room temperature more accurately. If the room temperature should fall below 2
degrees of the desired temperature, the unit will return to the full power mode until
the desired temperature is reached again.
6) Switch the Mode Key to "High" in order to have the heater stay on high heat
and not cycle on and off.
7) To turn the heater off, press the "Power" button, the fan will continue to run
until all of the heat has been expelled and will then turn off.
8) The heater is equipped with a temperature limiting control contained inside the
unit. If the heater stops working, shut the power off and let the unit cool down.
Turn the power back on and resume use. If the unit continues to shut down or the
unit does not reset itself, please contact us for service.
9) Humidifier: Use caution when filling the humidifier water chamber if the Heater
has been in use as the plastic can be hot.
To fill the humidifier chamber, make sure the heater is turned off. Open the
compartment on the left side of the heater. To open the door, pull gently down and
outward on the handle provided. Remove the water bottle. Fill the bottle with
distilled water and invert the bottle into the humidity tray. Once the water has filled
the tray refill the bottle a second time and invert it on to the humidity tray. The
humidifier is now primed. Close the humidifier compartment. Turn the humidifier
on. Once the unit is primed a bottle of water should last approximately 10 hours.
When the water has diminished the water light on the front of the unit will blink
and the humidifier will shut off until the water is replenished.
Yes: The heater can be safely and effectively operated without water.
® Signature Model
3