Care; Operation; Service - EdenPURE GEN3 500 Manual De Operación Y Garantía

Care • Operation • Service
READ ALL INSTRUCTIONS BEFORE USING THE HEATER
Operation – 7 step set-up for EdenPURE
1) Unpackage heater: cut open tape area, fold back flaps and gently turn
entire box upside down. lift box from styrofoam packing. Remove
styrofoam, turn upright. we recommend keeping the packaging for
off-season storage and any transport needs.
2) Find a level and unobstructed location to place the unpackaged heater.
3) Plug the power cord directly into an unused grounded
110 volt 15 amp or higher circuit receptacle. Push
the red rocker switch located on the front grill to
the "I" position to turn it on; it will glow red when
powered on.
4) Adjust the "temp up" and "temp down" buttons on
the rear of the heater until the desired temperature is
reached. Once the desired temperature is reached, the
heater will cycle on and off to maintain the room temperature.
5) To turn the unit off, press the rocker switch to the off position "O";
the fan will run until all internal heat has been expelled. The fan will
turn off automatically if the heater is unplugged.
6) The heater is equipped with a temperature limiting control contained in-
side the unit. If the heater stops working, shut the power off and let the
unit cool down. Turn the power back on and resume use. If the unit con-
tinues to shut down or the unit does not reset itself, please contact us for

service.

Cabinet Care – wipe clean with a soft damp cloth.
Heater Storage – when the heater is not going to be used for an ex-
tended period of time, please do the following:
1) Unplug Heater.
2) wind up electrical cord so as to keep it off of the ground.
3) Cover the heater to prevent dust from accumulating on filter
or internally.
4) Store the heater in a dry, low dust environment.
Service – To replace a heating element or for other repairs or service,
please call us toll-free at 1-800-219-8458.
SAVE THESE INSTRUCTIONS
All manuals and user guides at all-guides.com
4
GEN3 Model 500
®
= ON
= OFF