Insignia NS-HWG1955E Guia Del Usuario página 7

NS-HWG1955E-C_18-0256_MAN_V2_TRI-LANG.fm Page 7 Wednesday, April 25, 2018 9:12 AM
Step 2 Attaching the middle panels and side panels to the bottom
:
1 Insert eight hidden cams (2) into the large holes in the middle panels (D and E), and the shorter sides of the
bottom (G). The arrow in the hidden cam must point toward the hole in the edge of the panel.
2 Insert two wooden dowels (11) into the small holes in the edges of each middle panel (D and E) and six in the
edges of bottom (E), as shown below.
3 Stand the middle panels (D and E) on the bottom (G), as shown, then push the holes with the hidden cams onto
the cam screws on the bottom. The edges without the wooden pegs on both middle panels and the bottom
panel should point in the same direction.
4 Tighten each hidden cam with a Phillips screwdriver as tight as possible (about 180°).
5 Turn over the middle panel/bottom assembly and push the holes with the hidden cams on the bottom onto the
cam screws on the side panels (B and C). The edges with the wooden pegs on the side panels should be
pointing the same directions as the middle panels.
6 Tighten each hidden cam with a Phillips screwdriver as tight as possible (about 180°).
You'll need:
Phillips screwdriver
55" Wood or Black Finish TV Stand
2 Hidden cam (8)
www.insigniaproducts.com
11 Wooden dowel (10)
7