Orbegozo HU 2016 Manual De Instrucciones página 10

Idiomas disponibles

Idiomas disponibles

HU 2016
CARE AND MAINTENANCE
1. Switch the appliance off and unplug it.
2. Wipe the body of the appliance off with a soft damp cloth. If necessary use a little washing-up liquid.
3. Rinse the water tank with clean water after each use. To dry for storage, wipe with a soft clean cloth.
4. Do not use detergents to clean any part of the unit that normally contains water. Detergents can
interfere with the performance of the unit.
5. Do not immerse the humidifier in water or any other liquid.
6. Do not use harsh or abrasive cleaning agents or solvents.
CHECK THE MALFUNCTION AND REPAIR
If your humidifier can't work, please ask the service department to repair:
MALFUNCTION
1. Power indicator can't work
and with no wind and mist
2.Power indicator illuminate,
the unit with wind but no mist
3.Smelly mist
4.Power indicator illuminate,
the unit with no wind and mist
5.Little mist comes out of the
nozzle
6.Abnormal noise
TECHNICAL CHARACTERISTICS
Model No.
HU 2016
Voltage
220-240V
Frequency
50/60Hz
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment. The
crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of
the appliance, it must be separately collected. Consumers should contact their local authority or retailer for
information concerning the correct disposal of their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage Directive
2014/35/EU and the requirements of the EMC directive 2014/30/EU.
CAUSATION
Didn't connect the power supply
Didn't turn on the humidifier
No water in the water tank
New humidifier
Dirty water or long-time to store
water in water tank
Too much water in the base flume
Dirty ultrasonic transducer
Dirty water or long-time to store
water in water tank
Caused by little water in water tank.
Resonance from table-board
Consumption
Moisture output
Water tank Capacity
RESOLVE METHODS
Connect the humidifier from the power
supply
Switch on the unit
Fill water in water tank
Open water tank, put it in shadow for
12 hours.
Clean the water tank, fill clean water in.
Empty the flume, then close the cap of
water tank.
Clean the transducer
Clean the water tank, fill clean water in.
Fill water in water tank.
Place on a stable level surface.
20W
≥200ml/h
1.5 Litres
10
loading