Get Started; Installing The Nanoprotect Filter; Preparing For Humidification - Philips 2000 Serie Manual Del Usuario

3 Get started

Installing the
NanoProtect filter
Before using the appliance, remove all
packaging materials of the filter and
place it into the appliance described as
follows:
Note
•
Make sure that the side with the tag
is pointing towards you.
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig. c).
2
Press the clip down and pull the
pre-filter towards you (fig. d).
3
Remove all filters (fig. e).
4
Remove all packaging materials of
the NanoProtect filter (fig. f) .
5
Place the NanoProtect filter back
into the appliance (fig. g).
6
Put the pre-filter back into the
appliance, mount the pre-filter onto
the bottom of the appliance first,
and then push the clips on the top
of pre-filter against the appliance
(fig. h).
7
To reattach the back cover, mount
the panel onto the bottom of the
appliance first, and then push
the top of the panel against the
appliance (fig. i).
Preparing for
humidification
1 Pull out the water tank (fig. j).
2
Lift the water tray upwards and pull
it out horizontally (fig. k).
3
Remove all packaging material
of the NanoCloud rotary
humidification wick (fig. l).
Note
•
The humidification wick has been
assembled on the wick wheel upon
purchase.
4
Place the wick wheel on the wick
support (fig. m).
Note
•
When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
5
Place the water tray back into the
appliance (fig. n).
6
Turn the top cap of the water tank
anti-clockwise to unscrew it (fig. o).
7
Fill the water tank with cold tap
water (fig. p).
8
Turn the top cap clockwise to tightly
lock it onto the water tank (fig. q).
9
Place the water tank back into the
appliance (fig. r).
EN
7