Cleaning And Maintenance; Wearing Parts - Fiap Aqua Active Magic 10.000 Manual Del Usuario

FIAP Aqua Active Magic

Cleaning and maintenance

Attention! Always take the power plug out before cleaning or maintance!
Important! FIAP Aqua Active Magic: Never open the pump yourself! If the rotor is blocked with
dirt ask an electric expert!
The suction-sieve has to be cleaned regularly. A dirty or filled up suction-sieve reduces the capacity of
the device and causes an insufficient filtration. The blocked pump will turn on and off several times and
cause damage to the motor. In this case the guarantee is expired.

Wearing parts

The operation-unit, the bearing and slide ring gaskets are wearing parts and are not covered by the
guarantee.
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
11
www.fiap.com
FIAP Aqua Active Magic
Storage and overwinter
The device has to be uninstalled when there is frost. Clean it well and look for damage on the device.
For storage empty the device out completely and keep it frost-protected. Also empty out also frost-
endangered hoses. The plug connector must never be flooded!
Disposal
The device must be disposed by the national laws. Please ask your specialist dealer.
Failures
Failures
The pump does not start No power supply voltage
Pump does not pump Filter-sieve is blocked
Flow rate is insufficiant Filter-sieve is blocked
To high loss inside inlet pipe
Pump shuts down after a short Extreme water pollution
term Water temperature to high
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
Cause Solution
Check power supply voltage
Cleaning / control inlet pipe
Clean filter-sieve
Minimal length of hoses, do without
unnecessary connecting parts
Clean filter-sieve
Minimal length of hoses, do without
unnecessary connecting parts
Clean pump
Water temperature not higher than
+35°C
www.fiap.com
12