Ecurity Code; Ode; Measurement Procedure Of The Probes - Chauvin Arnoux C.A 1052 Manual De Instrucciones

4.7 Security code
It is possible to activate or to deactivate the security code of the instrument.
Selectr ON to activate or OFF to desactivate by the means of the up and down arrow. Validate by
pressing on OK.
4.8 Code
You can change the code thanks to this menu.
Change the number by pressing on up and down arrow, then go to the next number with right arrow.
Validate by pressing on OK.

5. MEASUREMENT PROCEDURE OF THE PROBES

Mise en route
To switch on the instrument, press the key "ON/OFF" for few seconds
Enter the code thanks to arrows (if locking is activate)
3 sub-menus are available :
Infos : The screen shows the name of the device, its serial number and firmware version
o
Probe: The probe menu is only available if the module or sensors are connected. It allows to
o
display information from sensors connected to the connection C2, Module, C1. The
information available are: type of sensor, serial number, status of the probe (active or
inactive selected using the up and down arrows).
In active mode, the probe is connected, the measurement is made and the value displayed.
In inactive mode, the probe is connected, the measure is not performed and no value is
displayed.
Settings : general adjustment of the instrument, see § 4
o
Select the submenu thanks to right and left arrow or thanks to quick access button.
Validate by pressing on OK.
Taking measurement
Connect the corresponding probe to the type of measurement which you wish to carry out to
reach the various menus
It is not possible at the same time to connect more than one probe
Select the submenu probe and validate by pressing on OK.
The apparatus automatically recognizes the inserted model and the screen displays the type of probe.
Select the submenu thanks to quick access button:
Infos
o
Params
o
Mesureament : to enter in measurement mode
o
Press on ESC to go back to last screen
To return to the homepage, disconnect the probe
To switch off the instrument, press some seconds on the "ON/OFF" key
English
Page 21