Makita AR410HR Manual De Instrucciones página 5

The hook is useful for hanging up the driver temporarily.
The mounting position of the hook on the driver can be
changed.
Remove the hook mounting screw, change position of
hook, and re-secure screw.
Switcher Mode Selection
(1)
1
009774
Steel sheet backing
Wood backing
Screw length
009794
Suitable for use on
thicknesses of 9.5mm (3/8"), 12.5mm (1/2") and 15mm
(5/8").
Steel sheet backing up to 0.8mm (1/32") thick can be
worked on (screws cannot be driven into layered steel
sheet backing).
Always use Makita genuine linked screws.
We recommend that in normal situations the driver be
used in Switching Mode (1), and set to Switching Mode
(2) when screws cannot be driven for lack of power.
ASSEMBLY
Loading Screws
CAUTION:
Always disconnect air hose from main unit before
•
loading screws.
If the main unit is operated by mistake, it may lead
•
to personal injury.
1. Disconnect air hose.
1. Knob
(2)
Steel sheet thickness
0.8 mm (1/32")
Steel sheet thickness
0.6 mm (1/64")
Steel sheet thickness
0.6 mm (1/64")
general plasterboard
This driver is equipped with a switcher to enable
selection of mode for optimum driving according to the
material of the workpiece.Set to mode positions shown
in "Switching
use.Thoroughly turn the knob until it clicks to a halt
properly at either position (1) or (2).If the driver is used
with the switcher in a position between (1) and (2), driver
components may become damaged, and/or normal
performance not achieved.
(2) (2)
(1) (1)
(1) (1)
(1) (1)
25 mm (1") 28 mm (1-1/16") 32 mm (1-1/4")
with 2. Press down lever while opening door.
009764
3. Open magazine cap.
009765
4. Load screws into magazine.
5. Pull out lead screw as far as driver guide and then
5
Mode Chart" below
(1)
41 mm (1-5/8")
1. Lever
1
1. Magazine cap
1
for optimum
(2)
(1).(2)
(1)
(1)