Tabla de contenido
Idiomas disponibles
Idiomas disponibles
9.4
OPERATION TIPS
Figure 9.
WARNING
Keep clearance between the body and the machine.
WARNING
Do not operate the machine without guard in place.
Do these tips when you use the machine
•
Keep the machine connected to the correctly worn
harness.
•
Keep a firm hold with the two hands on the machine
while you operate the machine.
•
Cut tall grass from the top down.
If grass winds around the trimmer head:
•
Remove the battery pack.
•
Remove the grass.
9.5
CUTTING TIPS
Figure 10.
•
Tilt the machine toward the area to be cut. Use the tip of
the cutting line to cut grass.
•
Move the machine from right to left to prevent thrown
debris toward the operator.
•
Do not cut in the dangerous area.
•
Do not force the trimmer head into uncut grass.
•
Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
9.6
LINE CUT-OFF BLADE
Figure 10.
This trimmer is equipped with a line cut-off blade on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the engine running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
10
MAINTENANCE
IMPORTANT
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
IMPORTANT
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
English
Use only the replacement parts and accessories of the initial
manufacturer.
10.1
GENERAL INFORMATION
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety glasses.
10.2
CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth dipped in
neutral detergent.
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or excessive
grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
10.3
REPLACE THE SPOOL
Figure 11 - 13.
1. Push the tabs on the sides of the trimmer head at the same
time.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Replace with a new spool.
Make sure that the cutting line is in the guide slot on the
new spool, and is extended approximately 5 in. before you
install the new spool.
5. Put the end of the cutting line through the eyelet.
6. Extend the cutting line to release it from the guide slot in
the spool.
7. Push the tabs and install the spool cover onto the spool
housing.
8. Push the spool cover until it clicks into position.
10.4
REPLACE THE CUTTING LINE
Figure 14 - 17.
9
IMPORTANT
IMPORTANT
NOTE
EN
Capítulos
Tabla de contenido
Solución de problemas
