Connecting Electricity; Electrical Shock Hazard - GE UNC15 Manual Del Propietário

IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
WARNING
This appliance contains isobutane refrigerant,
also known as R600a, a natural gas with high
environmental compatibility. However, it is also
combustible. Adhere to the warnings below to
reduce the risk of injury or property damage.
1. When handling, installing and operating the
appliance, care should be taken to avoid damage to
the refrigerant tubing.
2.
service parts.
3.
and Local Regulations. Flammable refrigerant and
insulation material used require special disposal
procedures. Contact your local authorities for the
WARNING
Plug into a grounded 3-prong outlet
Failure to follow these instructions can result in death, fire, or electrical shock.
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For
personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly
grounded.
Where a standard 2-prong wall outlet is encountered, it
is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
The ice maker should always be plugged into its own
READ AND SAVE THESE INSTRUCTIONS
4
FIRE OR EXPLOSION HAZARD Flammable Refrigerant

CONNECTING ELECTRICITY

ELECTRICAL SHOCK HAZARD

4. Keep ventilation openings in the appliance
enclosures or in the built-in structure clear of
obstruction.
5.
instrument to remove any frost or ice in the ice
maker compartment as it may puncture the liner and
then the flammable refrigerant tubing behind it.
6.
storage compartment of the appliance.
7.
thawing any ice or frost in your icemaker.
performance and also prevents overloading house
overheated wires.
Never unplug your ice maker by pulling on the power
cord. Always grip plug firmly and pull straight out from
the outlet.
Repair or replace immediately all power cords that
use a cord that shows cracks or abrasion damage
along its length or at either end.
When moving the ice maker, be careful not to roll over
or damage the power cord.
49-1000610 Rev. 0