Gb Installation Instructions; System Components; Safety Warnings - STEINEL GL 60 S Manual Del Usuario

GB Installation instructions

Dear Customer,
Congratulations on purchasing your new STEINEL
SensorLight and thank you for the confidence you
have shown in us. You have chosen a high-quality
product that has been manufactured, tested and
packed with the greatest care.

System components

Path light with stainless steel tube
Supply lead
Base plate
Stainless steel tubular pole
Stainless steel cover
Mains power supply
Sensor unit, turns through 120° for adjusting
the detection zone and G9 adapter

Safety warnings

n Disconnect the power supply before attempting
any work on the unit.
n During installation, the electrical wiring being con-
nected must be dead. Therefore, switch off the
power first and use a voltage tester to check that
the power supply is disconnected.
n Installing the SensorLight involves work on the
mains voltage supply. This work must therefore be
Principle
The integrated infrared sensor is equipped with three
120° pyro sensors which detect the invisible heat
emitted by moving objects (people, animals etc.).
The heat detected in this way is converted electronic-
ally into a signal that switches the light on automatic-
ally. Heat is not detected through obstacles, such as
walls or panes of glass. Heat radiation of this type
will, therefore, not trigger the sensor. The three pyro
Installation
The site of installation should be at least 50 cm away
from another light because heat radiated from it may
activate the system.
Connecting the mains supply lead (see illustration)
The mains leads consists of at least a 2-core
cable:
L
= phase conductor (usually black or brown)
N = neutral conductor (usually blue)
If you are in any doubt, you must identify the cables
using a voltage tester; now disconnect the
power supply again. Connect the phase (L) and neutral
conductor (N) to the clamp-type terminals. Insulation
Please familiarise yourself with these instructions
before attempting to install the sensor light because
prolonged reliable and trouble-free operation will only
be ensured if it is fitted properly.
We hope your new STEINEL SensorLight will bring
you lasting pleasure.
Twilight setting
Time setting
Basic light level (dimming)
Glass shade
Principle
Adjusting the detection zone
Manual override
carried out by a specialist in accordance with the
applicable national wiring regulations and electrical
operating conditions. (DE- VDE 0100,
AT-ÖVE/ÖNORM E 8001-1, CH- SEV 1000))
n Only use genuine replacement parts.
n Repairs may only be carried out by specialist
workshops.
sensors provide an angle of coverage of 360° with an
angle of aperture of 30°.
Important: The most reliable way of detecting motion
is to install the SensorLight with one of the sensor
apertures aligned parallel with the
direction in which a person would walk and by ensur-
ing that no obstacles (such as trees, walls etc.)
obstruct the line of sensor vision.
tape may be placed over any protective earth con-
ductor (PE, green/yellow).
Important: The supply lead must be at least 20 cm
longer than the support pole.
Note: A mains switch for switching the unit ON and
OFF may of course be installed in the power supply
lead. This is required for the manual override function
(see Manual override function)
Note: for technical reasons, the LED lamp may flicker
slightly to moderately at certain dimming levels. If this
occurs, alter the dimming level slightly.
- 9 -
.