KOBE IN-027 Serie Instrucciones De Instalación Y Manual De Operación página 9

Preparation Before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT
DEBRIS FROM ENTERING THE VENT OPENING.

Decide the location of the venting pipe from the hood to
the outside. Refer to Figure 1.

A straight, short vent run will allow the hood to perform
more efficiently.

Try to avoid as many transitions, elbows, and long run
as possible. This may reduce the performance of the
hood.

Temporarily wire the hood to test for proper operation
before installing.

Important: Peel protective film off the hood, if any.

Use duct tape to seal joints between pipe sections.
CAUTION
:
necessary to install the hood, turn off the power in an
electric range at the main electrical box. SHUT OFF
THE GAS BEFORE MOVING A GAS RANGE. And use a
protective covering
countertop from damage.
Custom Hood Preparation
1. The custom hood frame must be sized to shape and the
weight of the insert.
Diagrams on Page 13.
2. Install the Exhaust Plate using 4 screws.
Figure 2.
3. It must have a sturdy base (1/2 inch thick plywood
recommended) to sustain the weight of insert.
4. If an optional liner will be installed, the side of the wood
cabinet must be sturdy (1/2 inch thick plywood
recommended).
5. It is recommended to install a rear and front stud
support. Refer to Figure 3.
located 1-1/2" up from the base of the wood frame.
Liner Installation
6. The custom/wood hood must have a sturdy base to
accommodate the cut-out for the inset. The base must be
recessed to accommodate the height of the liner (See
liner dimension on Page 14)
7. Secure the liner to the bottom of the base using screws
(not included) appropriate for the size and material of your
wood frame.
8. Position the liner so that it aligns with the back edge of
the custom wood frame. Use a pen to trace the outline of
the pre-cut area. Remove the liner and proceed to Hood
Preparation Before Installation on Page 6.
9. Install the liner with 5 screws (not provided).
All manuals and user guides at all-guides.com
- For Insert installation -
If moving the cooking range is
to protect cooktop
Refer to Measurements and
The stud supports are
Figure 1
Figure 2
and/or
Refer to
Figure 3
7